A “chirping” sound means that it's time to change batteries. Because alarm sensors wear out, replace each alarm at least every 10 years. Also, alarms have labels showing when they were made. If you don't see a label, the alarm is old and must be replaced.
As the battery in a smoke alarm gets weak, the smoke alarm will “chirp” about once a minute to let you know that the battery needs to be replaced. Note: Only the device with a low battery will chirp. The other interconnected alarms should be silent.
Will a smoke alarm eventually stop chirping? A smoke alarm will eventually stop chirping if you do nothing. Once the battery has run out completely, the device will switch to residual power.
Your alarm manufacturer may have included a blinking red light to let you know it's time to test the alarm again. The Batteries are Low: Usually accompanied by a loud beep, a blinking red light could mean the batteries in the unit are low. Consider adding fresh batteries and running a test to make sure it's working.
What Does an Emergency Alarm Chirp Mean? This meaning is probably the most self-explanatory. When your carbon monoxide detector chirps 4 times in a row and pauses, this means it has detected unsafe levels of carbon monoxide. This means your entire household should evacuate immediately and seek fresh air.
Smoke detectors are an essential safety installation for every home. As important as they are, they can sometimes chirp for longer than necessary. This continuous sound can be so discomforting you can't help but wonder when it will end. A smoke detector chirps for at least 30 days before dying.
The most likely reason smoke detectors go off unexpectedly is that people aren't changing the batteries in them often enough. In most sensors you might think of, the strength of the signal goes up when they detect what they're supposed to. Common causes of smoke detector false positives around the house.
This battery characteristic can cause a smoke alarm to enter the low battery chirp mode when air temperatures drop. Most homes are the coolest between 2 a.m. and 6 a.m. That's why the alarm may sound a low-battery chirp in the middle of the night, and then stop when the home warms up a few degrees.
The smoke alarm is desensitized by pushing the Test/Hush button on the smoke alarm cover. If the smoke is not too dense, the alarm will silence immediately and the red LED blinks every 10 seconds. This indicates that the alarm is in a temporarily desensitized condition.
Different smoke alarms use the green and red LED to indicate the device's power status such that a flashing green means low battery while a constant blink means AC power is connected.
"Replace all smoke alarms, including those that use ten-year batteries and hard-wired alarms, when they are ten years old or sooner if they don't respond properly when tested." Each smoke detector should be replaced 10 years after the date of installation.
Replacing a hard-wired smoke detector is almost as easy as replacing a battery-powered version. New alarms are inexpensive. If your old alarms are connected to three wires as shown here, that means the alarms are interconnected — when one alarm detects smoke, they all howl.
Dust, Dirt and Environmental Smoke
Dust and dirt that comes from activities like remodeling may set off your smoke alarms. To clean your smoke alarm, open it up carefully, and look inside for dust or dirt. Use a vacuum attachment or electronic aerosol cleaner to remove dust particles.
Breathe shallowly through a cloth, wet if possible. Once outside, go to your selected meeting place and make sure everyone is there. Call the fire department from your neighbor's home. Do not return to your home until the fire officials say that it is alright to do so.
Low Battery
As the battery in a smoke alarm becomes weak, the smoke alarm will "chirp" about once a minute to alert you that the battery needs to be replaced. Note: Only the alarm with a low battery will chirp. No signal is sent through the interconnect wire. The other alarms will be silent.
A single chirp means the battery is low or the detector should be replaced.
3 Chirps approx. every 20 seconds Off Off Condition: Sensor Trouble/Sensor End-of-Life Alarm. Recommendation: Reset the alarm. If this does not clear the problem, replace alarm.
5 Beeps Every Minute: End of Life. This type of chirp indicates it is time to replace your carbon monoxide alarm.
If your First Alert smoke alarm beeps 3 times after a new battery is installed, try replacing the battery first. If the issue persists, check to make sure that the battery drawer is sliding in and out easily and completely.
If your detector or alarm has a blinking or steady light with no audible alarm sound, this typically indicates that the unit is receiving power.