Try a manual reset.
Remove the batteries and hold down the reset button for 15 to 20 seconds. Reconnect the batteries and alarm. It will most likely beep once as evidence it is working, then it should stop.
You can temporarily disable your alarm by pressing the reset button, removing the battery, or by checking your circuit breaker or fire control panel on more complicated systems.
Battery smoke detectors run solely on batteries. Hardwired smoke detectors run on electricity, but they also have a backup battery for power outages. When you hear a hard-wired smoke detector beeping, it means you need to replace its battery.
Many people consider it a difficult job to do. Most people ask themselves, “can I remove a hardwired smoke detector?” The answer is you can！ If you have to stop the hard-wired smoke detectors from beeping, you must unplug them from the clip and remove the battery.
A hard-wired smoke detector usually chirps because of 1 of these 3 problems: A dead backup battery. Dust inside your detector. Malfunctioning/old detector.
Taking the battery out of a smoke alarm will not make it stop beeping. Even after the battery has died, the detector maintains a residual charge that will keep the chirp going for at least seven days.
Most battery powered smoke detectors will beep for a minimum of 30 days before the battery dies. You'll know the battery is losing charge if you hear consistent beeping every 30 to 60 seconds.
Most importantly, if the smoke alarm in your property is disconnected, it could result in criminal charges if there is a fire on the premises. Although it is not illegal to disconnect a smoke alarm (for example, if you experience smoke with burning food), the detector should generally remain connected all the time.
Consistent Chirping
If a smoke alarm is chirping consistently, one of the following may be the reason: The battery may need to be replaced. An alarm will chirp every 30 to 60 seconds for a minimum of seven days. With a "low battery" announcement, disconnect the unit and replace the batteries.
As the battery in a smoke alarm becomes weak, the smoke alarm will "chirp" about once a minute to alert you that the battery needs to be replaced. Note: Only the alarm with a low battery will chirp. No signal is sent through the interconnect wire. The other alarms will be silent.
The "HUSH" feature has the capability to temporarily desensitize the smoke alarm circuit for approximately 7 minutes. This feature is to be used only when a known alarm condition, such as smoke from cooking, activates the alarm. The smoke alarm is desensitized by pushing the "HUSH" button on the smoke alarm cover.
What does it mean? This is the power indicator light: First Alert and BRK alarms have a power indicator light to show you that your alarm is receiving power. Some alarms have a red or green light that blinks every few minutes, while other models blink rapidly or shine a solid light.
Your alarm manufacturer may have included a blinking red light to let you know it's time to test the alarm again. The Batteries are Low: Usually accompanied by a loud beep, a blinking red light could mean the batteries in the unit are low. Consider adding fresh batteries and running a test to make sure it's working.
This battery characteristic can cause a smoke alarm to enter the low battery chirp mode when air temperatures drop. Most homes are the coolest between 2 a.m. and 6 a.m. That's why the alarm may sound a low-battery chirp in the middle of the night, and then stop when the home warms up a few degrees.
Taking the battery out of a smoke alarm will not make it stop beeping. Even after the battery has died, the detector maintains a residual charge that will keep the chirp going for at least seven days.
It's a sound many homeowners have heard: the 3 a.m. alarm chirp. Why does it happen? Well, it's a simple matter of the battery's charge level and a home's air temperature. As a smoke alarm's battery nears the end of its life, the amount of power it produces causes an internal resistance.
You may have batteries getting old. You need a battery tester (not expensive). Even new batteries can be faulty, and supply low voltage to an appliance. This will cause a fire alarm to false-trigger, sometimes.
Most battery powered smoke detectors will beep for a minimum of 30 days before the battery dies. You'll know the battery is losing charge if you hear consistent beeping every 30 to 60 seconds.
While your smoke alarm sounds, pressing the hush button will silence the smoke alarm for approximately 10 minutes. The hush feature is typically used where an alarm has been triggered accidently. This provides time to clear the current environment of fumes that triggered the alarm without the alert tone sounding.